[Bug]: Camera alarms don't clear after being fixed

[JoeTheBroseph]

Checks

• I have searched the bug with a few keywords, and I confirm this bug was not yet reported.
• The round I am reporting the bug from, or I am going to talk about, has already ended.

Location

Horizon

Describe the issue

Whenever a camera is fixed by actually repairing the camera (with welder and cable) the camera alarm for that camera wont clear up. This has been going on for a long time now, at least a few months, and happens regularly, as in it happens every single time.

Repairing a camera that has had the wire snipped by mending the snipped wire will fix the alarm immediately, so this only applies to cameras that have been broken and repaired.

Sometimes the camera alarms have cleared up on their own with time, but it's not clear what clears this up and if there's a set amount of time before the camera alarm clears after being fixed.

How to reproduce

1. Destroy camera with brute force
2. Repair
3. Camera alarm will probably still exist

Round ID

No response

Staff ckey

No response

[Syncrosync]

This one is a bit of a spooky ghost issue for me. As the AI, I've seen the issue, asked engineering to fix it, which they did, and the alarm went away like 20 minutes later. Other times it doesn't. So not sure whats up there.

[NonQueueingMatt]

I might have fixed it - reopen if not