Gridlabd build issue with helics 2.6.0 #1576
-
|
If we build gridlabd from source with helics 2.6.0, simulation never enters into execution mode or if it does, it gets stuck at h.helicsFederateRequestTime(fed, t). If we build gridlabd with helics 2.4.0, everything works fine. Note that once gridlabd built with helisc 2.4.0, it works fine with both helics 2.4.0 and helics 2.6.0 python packages. |
Beta Was this translation helpful? Give feedback.
Replies: 3 comments 1 reply
-
|
Probably something for @afisher1 to look into. Any thoughts, Andy? |
Beta Was this translation helpful? Give feedback.
-
|
@asinghal91; has this issue been resolved? |
Beta Was this translation helpful? Give feedback.
-
|
Since it is working with helics2.4.0 and I am happy with it, I did not try again with helics2.6.0. So, I am not sure if the issue is resolved or not. |
Beta Was this translation helpful? Give feedback.
-
|
@asinghal91, I'm going to close out this discussion. If you are still needing help with HELICS, let me know. By the way, v3 has been released and we are recommending all users that are working on projects that will be around for many more months or years make the switch. Generally, the changes are relatively minor. |
Beta Was this translation helpful? Give feedback.
@asinghal91, I'm going to close out this discussion. If you are still needing help with HELICS, let me know.
By the way, v3 has been released and we are recommending all users that are working on projects that will be around for many more months or years make the switch. Generally, the changes are relatively minor.