Why is EnableHardwareAccelerationInRdp an opt-in ?!

[Symbai]

Can someone explain in a short answer why hardware acceleration in RDP has been made an opt-in instead of opt-out?! On the whats new in .NET 8 its just saying that this new option is so much better versus the old. No disadvantage is mentioned. Is there one? And if not, why its an opt-in then?!

PS: I also tried reading discussion in the PR but I couldn't find a clear statement for someone not knowing whats going on in code base. And it seems no documentation exists yet.

[pchaurasia14]

Below are the reasons why this is made opt-in instead of opt-out -

1. Changes are at a relatively lower-level (wpfgfx).
2. Lack of adequate test coverage in this area
3. The change was very close to .NET 8 release cycle, which does not give us enough time to fix any issues (should there be any)

This is explained in the comments here and here

[Symbai]

Sounds like "we didn't have enough time to fully test it". So with .NET 9 it could become enabled by default?!

[pchaurasia14]

Yes, that's the plan.