Gotek SFR1M44-DU emulator with F415 chip

[RaceRon]

I need the small form factor because I was trying to install it into a Tektronix TDS754D oscilloscope. This unit has the 26 pin flat flex cable
connector, the current FF download doesn't work and my question is when I looked at some of the source code( I am not a C expert) it seemed to me that some pin definitions don't match what I have found on the internet for a 26 pin interface definition. Is there a special
FF version that is written for this specific interface?

[keirf]

See #155 where users have got this working. Some soldering is required, but the floppy pins are at least already routed correctly to the 26-pin header.

[RaceRon]

Yes this doesn’t work on my scope, where are the source files for the 26 pin interface connector? The board.c and floppy.c under gotek file in flash floppy master are for a 34 pin connector!ThanksOn Sep 3, 2024, at 2:59 AM, Keir Fraser ***@***.***> wrote: See #155 where users have got this working. Some soldering is required, but the floppy pins are at least already routed correctly to the 26-pin header. —Reply to this email directly, view it on GitHub, or unsubscribe.You are receiving this because you authored the thread.Message ID: ***@***.***>

[keirf]

There is no specific handling of the 26-pin interface in the firmware. Everything is defined in terms of the Shugart 34-pin interface.