Connection lost after router reboot

[cigas4]

Everything was working fine until I had to restart my router. After that connection to GoHeishaMon was lost and never recovered (all entities went to unavailable in Homeassistant).
I am using CZ-TAW1 module connected over eth cable.
It is not retrying to reconnect after connection was lost?
How should I proceed in this situation? I don’t want to power cycle complete A2W system every time I reboot my router.

[lsochanowski]

did you enable ssh access? on taw?
if so can you send me a logs from goheisha? i cannot reproduce ;/

[cigas4]

did you enable ssh access? on taw?
if so can you send me a logs from goheisha? i cannot reproduce ;/

Hi, I do have “EnableCommand=true” in my config file but I am not able to connect to ssh.

[lsochanowski]

but there is more to do than only seting enableconfig to enable ssh access
please look at readme
https://github.com/lsochanowski/GoHeishaMon

[cigas4]

but there is more to do than only seting enableconfig to enable ssh access
please look at readme
https://github.com/lsochanowski/GoHeishaMon

Hi, yes you are right, I tried executing these following steps, but it looks like nothing happened:

Public in MQTT topic "panasonic_heat_pump/OSCommand" (or eqvivalent with is set as Mqtt_set_base) one by one values: "umount /overlay" , "jffs2reset -y" and finally "reboot". This will perform a so called firstboot. You can see the output console in topic"panasonic_heat_pump/OSCommand/out".

From HA I sent MQTT message to panasonic_heat_pump/OSCommand with payload umount /overlay, jffs2reset -y and reboot. But nothing happened, also I saw no messages coming on topic panasonic_heat_pump/OSCommand/out.
What is correct way to do it? Maybe topic is not correct, what do you mean "or eqvivalent with is set as Mqtt_set_base"?

I have also tried restarting my router one again, then also HA itself, but issue didn't appeared this time. Last time when issue appeared, I shut down HA and modem/router for some electricity works (for about an hour or so). CZ was on during this time. Maybe longer time without connection LAN or MQTT server causes issue.